Researchers Dong Ji, Jia Shi, Zhu Zhao, Fengbo Liu, Chenghu Guo, Yongqi Wang, and Subo Tian have evaluated a multi-objective calibration method using the NSGA-II algorithm to optimize discrete element simulation parameters for a 16 by 8 hole seedling pot. The work aims to improve simulation accuracy for agricultural transplanting operations and support the future optimization of key transplanter machinery components.
To calibrate the discrete element model, the team conducted basic physical tests alongside puncture and shear experiments to evaluate contact parameters. Using a Plackett-Burman test design, the researchers screened initial parameters and established their respective value ranges. The analysis revealed that three specific factors significantly influenced puncture and shear forces: shear strength, designated as X2; the static friction coefficient, designated as X4; and the ultimate stress, designated as X10.
Following this parameter screening, the authors established a two-objective regression model for puncture force and shear force using a central composite design, deriving parameter values through Design-Expert software. When parameter values for X2, X4, and X10 were set to 1.4, 0.885, and 0.115, the model predicted puncture and shear forces of 6.4 N and 11.62 N. While the measured laboratory values were 6.4 N and 11.3 N, the software solution emphasized puncture force over shear accuracy.
When these values were entered into Altair EDEM 2022 software, the resulting discrete element simulations yielded values of 7.2 N for puncture force and 10.1 N for shear force. These outputs produced relative errors of 12.5 percent and 10.6 percent compared to physical measurements, highlighting calculation defects in the initial approach.
To resolve these discrepancies, the researchers implemented multi-objective optimization using the NSGA-II algorithm directly on the EDEM parameter model. From this process, a set of optimized Pareto optimal solutions was selected and simulated. The refined model reduced the relative errors to 6.25 percent for puncture force and 7.08 percent for shear force, indicating the potential feasibility of the NSGA-II calibration method under the investigated experimental conditions.
Subject of Research: Discrete element simulation parameter calibration for seedling pots using the NSGA-II algorithm
Article Title: Calibration and experimental verification of discrete element simulation parameters of seedling pot based on NSGA-II algorithm
Article References: Ji, D., Shi, J., Zhao, Z., Liu, F., Guo, C., Wang, Y., & Tian, S. (2026). Calibration and experimental verification of discrete element simulation parameters of seedling pot based on NSGA-II algorithm. PLOS One, 21(11), e0361917. https://doi.org/10.1371/journal.pone.0361917
Image Credits: AI Generated
DOI: 10.1371/journal.pone.0361917
Keywords: seedling pot, discrete element simulation, NSGA-II algorithm, EDEM simulation, puncture force, shear force, Plackett-Burman test, central composite design, Design-Expert software, Pareto optimal solutions, shear strength, static friction coefficient, ultimate stress, transplanter optimization, parameter calibration, multi-objective optimization, contact parameters
Cite Scienmag News
Scienmag. (November 21, 2026). Algorithm Calibrates Discrete Element Simulation Parameters for Seedling Pots. https://scienmag.com/algorithm-calibrates-discrete-element-simulation-parameters-for-seedling-pots/
Scienmag. "Algorithm Calibrates Discrete Element Simulation Parameters for Seedling Pots." Scienmag, 21 November 2026, https://scienmag.com/algorithm-calibrates-discrete-element-simulation-parameters-for-seedling-pots/. Accessed 21 November 2026.
Scienmag. "Algorithm Calibrates Discrete Element Simulation Parameters for Seedling Pots." Scienmag. November 21, 2026. https://scienmag.com/algorithm-calibrates-discrete-element-simulation-parameters-for-seedling-pots/








